How an ice dam forms
- Warm air from the house leaks into the attic through gaps around lights, plumbing, chimneys and the attic hatch.
- The roof deck warms above freezing, and the snow on it melts from underneath, even when it's well below freezing outside.
- Meltwater runs down to the cold overhang at the eaves and refreezes into a ridge of ice.
- More meltwater pools behind the ridge, works its way under the shingles and leaks into the walls and ceilings.
Deep snow makes it worse: a foot of snow insulates the roof deck at roughly R-10 to R-15, holding in the attic's warmth.
If you have an ice dam now
- Take snow off the lower roof with a roof rake from the ground, so less meltwater feeds the dam.
- Don't chip, hammer or use a blowtorch. You'll damage shingles and gutters.
- Watch inside for stains on ceilings and exterior walls, and note where they are.
- Call us for a safe removal and to find where the heat is escaping.
The permanent fix
Ice dams are an attic problem that shows up on the roof. The Department of Energy's building research program lays out the fix in order of importance:
- Air seal the attic floor. Air leakage into the attic is one of the biggest causes of ice dams, and sealing the ceiling plane is the most important step.
- Insulate. ENERGY STAR recommends R-60 for an uninsulated attic in our climate, or R-49 when adding to existing insulation, with extra care over the tops of exterior walls.
- Ventilate. Balanced intake at the soffits and exhaust at the ridge keeps the roof deck cold. Baffles keep insulation from blocking the soffit vents.
- Protect the roof edge. Self-adhering ice and water barrier from the eaves to at least 24 inches inside the exterior wall, measured horizontally. On many roofs that takes more than one roll.
We handle all four: attic insulation and ventilation and roof replacement with full ice barrier. Gutters that pull away under ice? See our gutter guide.




